Shock absorber, rear, 4WD
|
|
Shock absorber, rear, 4WD
|
|
2.
|
Relieve the weight on the lower suspension arm using an pillar jack.
|
|
3.
|
Remove the bolt (A) securing the shock absorber to the body and slacken the bolts (B) a few turns.
|
|
4.
|
Remove the bolt (A) holding the shock absorber to the steering swivel member and lift away the shock absorber.
|
|
5.
|
Remove the bracket (A) with bush and bump stop (B) with protective sleeve from the shock absorber.
|
|
1.
|
Fit the bump stop (B) with protective sleeve and bracket (A) with bush to the shock absorber.
Tightening torque 27 Nm (20 lbf ft)
|
|
2.
|
Fit the bolt (A) to the shock absorber bracket. Tighten the bolts (A) and (B).
Tightening torque 53 Nm (39 lbf ft)
|
|
3.
|
Lift the steering swivel member to normal position, 374 mm, 9-3X 390 mm (A) between the centre of the drive shaft and the edge of the wing.
|
|
4.
|
Fit the shock absorber (A) to the steering swivel member.
Tightening torque 148 Nm +90° (109 lbf ft +90°)
|
|
5.
|
Lower the car to the floor.
|
