PRE-RELEASE
Receiver, high pressure pipe, B284
| Receiver, high pressure pipe, B284 |
| Important | ||
|
The A/C receiver and the compressor oil absorb moisture from the air, which can then not be removed. Plug all connections that are opened immediately. |
||
| To remove |
| 1. |
Drain the refrigerant from the A/C system, see
Draining and filling the refrigerant
.
|
|
| 2. |
Remove the air filter housing cover.
|
|
| 3. |
Detach the mass air flow sensor pipe.
|
|
| 4. |
Remove the right
headlamp
.
|
|
| 5. |
Detach the upper PAD connection on the condenser. Plug the openings.
|
|
| 6. |
Dismantle the PAD connection from the receiver. Plug the openings.
|
|
| 7. |
Dismantle PAD connection on the front right structural member. Plug the openings.
|
|
| 8. |
Lift out the receiver's high pressure pipe.
|
|
| To fit |
| 1. |
Adjust the oil quantity in the A/C system. See
Filling and adjusting the compressor oil
.
|
|
| 2. |
Insert the receiver's high pressure pipe into position.
|
|
| 3. |
Fit the receiver's high pressure pipe to the reciever using a new seal.
Tightening torque 18 Nm (13 lbf ft) 
|
|
| 4. |
Fit the receiver high pressure pipe to the PAD connection on the front right structural member using a new seal.
Tightening torque 15 Nm (11 lbf ft) 
|
|
| 5. |
Attach the upper PAD connector to the condenser using a new seal.
Tightening torque 15 Nm (13 lbf ft) 
|
|
| 6. |
Fit
headlamp
.
|
|
| 7. |
Attach the mass air flow sensor pipe.
|
|
| 8. |
Fit the air filter housing cover.
|
|
| 9. |
Vacuum pump and fill the A/C system with refrigerant. See
Draining and filling the refrigerant
.
|
|
| 10. |
Test the A/C system. See
A/C system performance test
|
|
