PRE-RELEASE
Side window, front door
| Side window, front door |
| To remove |
| 1. |
Open the window approx. 5 cm.
|
|
| 2. |
Remove
Door trim, front, 4D
and fold down the water barrier.
|
|
| 3. |
Remove the outer weatherstrip. Lift up the rear edge using the removal tool.
|
|
| 4. |
Pull the strip out from the base of the door mirror.
|
|
| 5. |
Slacken the bolts to release the window.
|
|
| 6. |
Raise the rear edge of the window, angle it out slightly and lift it up.
|
|
| To fit |
| 1. |
Insert the front edge of the window into the U-moulding. Angle in the rear edge so that it is located in the rear U-moulding. Make sure that the window is correctly seated in the channels by raising and lowering it.
|
|
| 2. |
Press the window down into the rubber-covered brackets. (Image from outside)
|
|
| 3. |
Tighten the bolts.
|
|
| 4. |
Fit the outer weatherstrip. Press the weatherstrip in under the base of the door mirror then press it home along the top edge of the door.
|
|
| 5. |
Plug in the window lift connector to the door trim. Close and open the window a few times to check its operation.
|
|
| 6. |
Fit the water barrier and
Door trim, front, 4D
.
|
|
| 7. |
Cars with pinch protection
: Perform
Calibration of pinch protection
.
|
|
| 8. |
Clean the window.
|
|
