PRE-RELEASE
Position sensor, soft top raised and soft top lowered (577c/o)
| Position sensor, soft top raised and soft top lowered (577c/o) |
| To remove |
Only the hydraulic cylinder on the right-hand side of the car has two position sensors. Both position sensors have one common black connector and can therefore only be changed together.
| 1. |
Open the soft top cover. Raise the sixth bow and support it with
82 93 847 Soft top support
.
|
|
| 2. |
Remove the clip from the cylinder piston rod fastening pin.
|
|
| 3. |
Remove the pin from the cylinder piston rod.
|
|
| 4. |
Remove the clip from the outer fastening pin in the hydraulic cylinder.
|
|
| 5. |
Remove the outer pin (by the spanner flats).
|
|
| 6. |
Pull the cylinder to the side so that it goes free of the inner pin (which is fixed)
|
|
| 7. |
Open the cable tie for the position sensor cable.
|
|
| 8. |
Remove the position sensor cable connector (black).
|
||||||||||
| 9. |
Use a screwdriver to carefully loosen the two position sensors from the hydraulic cylinder. Move the hydraulic line to one side at the same time.
|
|
| To fit |
| 1. |
Put the position sensors in mounting position on the hydraulic cylinder and fit them. Move the hydraulic line slightly to one side at the same time.
|
|
| 2. |
Connect the position sensor cable connector.
|
|
| 3. |
Fit the cable ties for the position sensor cable.
|
|
| 4. |
Fit the cylinder to the inner fastening pin. Press in the outer pin (by the spanner flats) and fit the lock.
|
|
| 5. |
Fit the pin to the cylinder piston rod.
|
|
| 6. |
Fit the lock to the fastening pin.
|
|
| 7. |
Remove the soft top support and close the soft top.
|
|
| 8. |
Test the operation of the soft top.
|
|
| 9. |
Connect the diagnostics tool and erase any diagnostic trouble code.
|
|
