SAAB WIS ONLINE

PRE-RELEASE

Front catalytic converter, Z19DTR

Front catalytic converter, Z19DTR

To remove


1. Remove Preheated oxygen sensor (136), Z19DTR.

2. Raise the car.

3. Remove the lower heat shield (A).


4. Detach the exhaust temperature sensor (B).

5. Remove the exhaust pipe's nuts (C).

6. Slacken the clamp's nut (D).

7. Suspend the exhaust pipe with 83 95 212 Strap (A) and undo its two mountings (B).


8. Hold the clamp open with circlip pliers or the like and lower the catalytic converter.


To fit


1. Clean the sealing surfaces.


2. Position the catalytic converter and fit it using a new gasket. Hold the clamp open slightly with circlip pliers. Turn the clamp so that the nut points up. Tighten the clamp's nut so that the catalytic converter can still be turned.

3. Replace the gasket and position the exhaust pipe's nuts. Lubricate with 90 513 210 Universal paste .

4. Fit the nuts and bolts of the front and rear mounting (B).


5. Tighten the nuts and bolts of the front and rear mounting (B).

Tightening torque 19 Nm (14 lbf ft)

6. Tighten the clamp's nut (D).

Tightening torque 20 Nm


7. Remove the strap.

8. Tighten the exhaust pipe's nut (C).

Tightening torque 22 Nm (16 lbf ft)

9. Fit the exhaust temperature sensor (B).

10. Fit the lower heat shield (A).

11. Fit Preheated oxygen sensor (136), Z19DTR.

12. Lower the car.

13. If a new catalytic converter is fitted : Connect the diagnostic tool to reset adaptation values. Select Menu - Engine - Engine management system - Adjustment - Pre Catalyst Replaced.

14. Connect an exhaust hose and start the engine. Check the exhaust system for leaks.


PRE-RELEASE