PRE-RELEASE
Wiring harness, front door
| Wiring harness, front door |
| To remove |
| Note | ||
|
If the car is equipped with a radio other than a genuine Saab radio, check that the customer has the radio code before commencing work. |
| 1. |
Undo the cable for the battery's negative terminal.
|
|
| 2. |
Remove the
Door trim, front
.
|
|
| 3. |
Remove the
Speaker, front door
.
|
|
| 4. |
Remove the door harness.
|
|
| • |
Carefully mark all connectors before disconnecting them from their components.
|
| • |
Carefully remove the water barrier from the door (A).
|
| • |
Remove the inner cover (A) for the door mirror and uncouple the connection (B).
|
| • |
Dismantle the connection for the door mirror (C).
|
| • |
Unplug the connector between the door and the A-pillar (A).
|
| • |
Remove the connector from the door (B).
|
| • |
Dismantle the connection for the window lift (A).
|
| • |
Dismantle the connection for the door lock (B).
|
| • |
If the wiring harness is being re-used, remove the clips (C), x 8, carefully so that they can be re-used.
|
| To fit |
| 1. |
Fit the door harness (C).
|
|
| • |
Route the new wiring harness the same way as the old one and secure it in the same way.
Take care that all grommets are firmly sealed. |
| • |
Plug in the connectors to the respective component. If in doubt, consult the wiring diagrams/component lists of the system in question.
|
| • |
Plug in the connector for the door lock (B).
|
| • |
Plug in the connector for the window lift (A).
|
| • |
Fit the connector for the door (B).
|
| • |
Plug in the connector between the door and the A-pillar (A).
|
| • |
Plug in the connector for the door mirror (C).
|
| • |
Connect the contact (B) to the inner cover for the door mirror and fit it (A).
|
| • |
Fit the water barrier to the door (A).
|
| 2. |
Fit the
Speaker, front door.
|
|
| 3. |
Fit the
Door trim, front
.
|
|
| 4. |
Connect the negative cable of the battery.
|
|
| 5. |
Set the clock and program any radio code.
|
|
| 6. |
Cars with pinch protection: Carry out
Programming the pinch protection
.
|
|
| Important | ||
|
Fasten the wiring harness correctly so that there is no risk of it chafing or rattling. |
||
| Note | ||
|
Spray all the connectors with "Kontakt 61" to prevent verdigris formation. Clean all the grounding points and coat them with Vaseline. |
