PRE-RELEASE
Complete unit, differential clutch and limited slip differential
| Complete unit, differential clutch and limited slip differential |
|
|||||||
Warning
| To remove |
| 1. |
Carry out
Before changing a control module
.
|
|
| 2. |
Remove
Drive shafts, rear, 4WD
left and right-hand sides.
|
|
| 3. |
Remove
Complete exhaust system, 4WD
.
|
|
| 4. |
Remove
Propeller shaft
.
|
|
| 5. |
Release the catches (A) from the control module and remove the protective cover (B) from the hydraulic pump.
|
|
| 6. |
Loosen the cable clip (A)
|
|
| 7. |
Remove the electrical connector (A).
|
||||||||||
| 8. |
Use a column jack as support for the differential clutch, secured with straps (A).
|
|
| 9. |
Remove the bolts (B) to the differential clutch and limited slip differential.
|
|
| 10. |
Lower the differential clutch and limited slip differential.
|
|
| To fit |
| Important | ||
|
Be careful that the differential clutch control module does not get damaged. |
||
| 1. |
Use a column jack as support for the differential clutch, secured with straps (A).
|
|
| 2. |
Raise the differential clutch and limited slip differential.
|
|
| 3. |
Fit the bolts (B) to the differential clutch and limited slip differential.
Tightening torque 90 Nm (66.3 lbf ft) +90°+15° |
|
| 4. |
Fit the electrical connector (A).
|
|
| 5. |
Fit the cable clip (A).
|
|
| 6. |
Fit
Propeller shaft
.
|
|
| 7. |
Fit
Complete exhaust system, 4WD
.
|
|
| 8. |
Fit
Drive shafts, rear, 4WD
, left and right-hand sides.
|
|
| 9. |
Fit the Protective cover (B) on the hydraulic pump and lock the catches (A) to the control module.
|
|
When replaced, carry out After changing a control module .
