PRE-RELEASE
Valve, limited slip differential clutch, replacement
| Valve, limited slip differential clutch, replacement |
|
|||||||
Warning
| Important | ||
|
It is very important to observe maximum cleanliness when working on the differential clutch. Dirt particles can seriously damage the function and service life of the differential clutch. |
||
| To remove |
| 1. |
Raise the car.
|
|
| 2. |
Remove the
exhaust system
.
|
|
| 3. |
Remove the
propeller shaft
.
|
|
| 4. |
Unhook the hooks (A) from the control module and remove the protective cover (B) from the hydraulic pump.
|
|
| 5. |
Undo the cable clips (A).
|
|
| 6. |
Remove the electrical connection (A).
|
|
| 7. |
Use a column jack as support for the differential clutch and limited slip differential, secure with strap (A).
|
|
| 8. |
Remove the bolts (B) for the differential clutch and limited slip differential.
|
|
| 9. |
Lower the differential clutch and limited slip differential as far as the valve can be removed, take care that the drive shaft universal joints are not damaged.
|
|
| 10. |
Remove the electrical connection (A).
|
|
| 11. |
Remove the valve with cover.
|
|
| 12. |
Remove the valve from the cover.
|
|
| To fit |
| 1. |
Fit the valve in the cover.
|
|
| 2. |
Fit the valve with cover (B).
Tightening torque: 2.9 Nm (2.1 lbf ft) 
|
|
| 3. |
Fit the electrical connection (A).
|
|
| 4. |
Raise the differential clutch and limited slip differential.
|
|
| 5. |
Fit bolts (B) for the differential clutch and limited slip differential.
Tightening torque: 90 Nm (66.4 lbf ft) + 90°+15°
|
|
| 6. |
Remove the strap (A).
|
|
| 7. |
Fit electrical connection (A).
|
|
| 8. |
Fit cable clip (A).
|
|
| 9. |
Fit the protective cover (A) to the hydraulic pump and hook the hooks (B) into the control module.
|
|
| 10. |
Fit the
propeller shaft
.
|
|
| 11. |
Fit the
exhaust system
.
|
|
| 12. |
Lower the car to the floor.
|
|
