Clamping piece, gear cable
|
|
Clamping piece, gear cable
|
|
1.
|
Remove the floor console's front side pieces on the driver's side (A).
|
|
2.
|
Remove the floor console's left-hand lower support (A).
|
|
3.
|
Remove the cover from over the gear lever housing (A), use
82 93 474 Removal tool
in the rear edge of the cover and pull back. Press down a screwdriver blade carefully in the cable adjuster and prise slightly towards the gear lever. A click will be heard when the adjuster catch has disengaged. Repeat the procedure on the other cable adjuster.
|
|
4.
|
Remove the clamping piece (A) carefully from the gear lever using
KM-6065 Removal tool
(cable clamp: movement right/left)
|
|
5.
|
Remove the clamping piece (B) carefully from the gear lever using K
M-6065 Removal tool
(cable clamp: movement forward/backward)
|
|
1.
|
Fit the clamping piece (cable clamp: movement forward/backward). Insert the cable in the clamping piece. Press in the clamping piece on the ball end.
|
|
2.
|
Fit the clamping piece (cable clamp: movement right/left). Insert the cable in the clamping piece.
|
|
3.
|
Fit the floor console's left-hand lower support (A).
|
|
4.
|
Fit the floor console's front side pieces on the driver's side (A).
|
