PRE-RELEASE
Handbrake cable, 4WD
| Handbrake cable, 4WD |
| To remove |
| 1. |
Remove the front side piece (A) from the appropriate side of the floor console.
|
|
| 2. |
Remove the floor console's rear cover (A).
|
|
| 3. |
Remove the rear side cover (B) from the appropriate side of the floor console.
|
|
| 4. |
Release the handbrake, remove the cable ferrule (A) from the bracket and the cable (B) from the lever mechanism.
|
|
| 5. |
Remove the rear seat seat cushion
.
|
|
| 6. |
Lift up the carpet and remove the cable from the mounting in the floor.
|
|
| 7. |
Raise the car.
|
|
| 8. |
Remove the protective cover (A).
|
|
| 9. |
Remove the cable from the actuating lever (A) on the wheel cylinder and from the mountings (B).
Right-hand side: Remove the wiring harness from the mounting on the tank strap and the clips from the cable. 
|
|
| 10. |
Remove the rubber grommet (C) and pull out the cable.
|
|
| To fit |
| 1. |
Route in the cable.
|
|
| 2. |
Lower the car.
|
|
| 3. |
Route the cable correctly.
|
|
| 4. |
Raise the car.
|
|
| 5. |
Fit the cable into its mountings (B) and connect the cable to the actuating lever (A).
|
|
| 6. |
Fit the rubber grommet (C).
Right-hand side: Fit the wiring harness to the mounting on the tank strap and the clips to the cable. |
|||||||
| 7. |
Fit the protective cover (A).
|
|
| 8. |
Lower the car.
|
|
| 9. |
Fit the cable (B) to the lever mechanism and the cable ferrule (A) to the bracket.
|
|
| 10. |
Fit the cable to the bracket on the floor.
|
|
| 11. |
Check that the cable's rubber grommet in the floor is correctly fitted.
|
|
| 12. |
Put the floor carpet in place.
|
|
| 13. |
Fit the rear seat seat cushion
.
|
|
| 14. |
Apply the handbrake to tension the cable.
|
|
| 15. |
Release the handbrake.
|
|
| 16. |
Check and adjust the handbrake cable
.
|
|
| 17. |
Fit the floor console's rear side piece (B).
|
|
| 18. |
Fit the floor console's rear cover (A).
|
|
| 19. |
Fit the floor console's front side piece (A).
|
|
