PRE-RELEASE
Defrost air distribution flap stepping motor
| Defrost air distribution flap stepping motor |
| To remove |
| 1. |
Dismantle the
driver's acoustic insulation
.
|
|
| 2. |
Dismantle the air duct for the floor vent.
The defrost air distribution flap stepping motor is located at the top front on the heating and ventilation unit's left hand side. 
|
|
| 3. |
Remove the screws from the stepping motor.
|
|
| 4. |
Carefully lift out the stepping motor a little. Turn the stepping motor so that it releases from the link arm.
|
|
| 5. |
Dismantle the stepping motor's connector by pressing in the lock and pulling out the connector.
|
|
| To fit |
| 1. |
Connect the connector to the stepping motor. Make sure the connector locks correctly.
|
|
| 2. |
Fit the stepping motor to the link arm and align the steeping motor on the guide pin.
|
|
| 3. |
Fit the stepping motor.
|
|
| 4. |
Fit the air duct for the floor vent.
|
|
| 5. |
Fit the
driver's acoustic insulation
.
|
|
