PRE-RELEASE
Motor, air distribution, floor (715)
| Motor, air distribution, floor (715) |
| Location |
Motor, air distribution, floor (715) .
| Main task |
The stepping motor is connected via a linkage to damper for the floor vent, which is used for both climate zones.
| Type |
The unipolar stepping motor consists of a rotor (10 poles) and four stator windings. A gearbox transfers the power from the rotor to the lever which controls the damper.
| Connect |
The four stepping motor windings receive a common B+ feed from ACC unit pin 32 (K32).
The ACC unit grounds each winding (pin 10, 27, 11 and 12 in K32) in a specific order thus operating the motor in short pulses, which explains the name stepping motor. The rotational direction can be changed.
When the stepping motor is stationary, two windings are continuously grounded in order to lock the motor. The stepping motor does not need to be reconnected to the control module (position sensor). By sending a specific number of ground pulses, the ACC unit knows how far the air distribution damper has moved.
Wiring diagram
