PRE-RELEASE
Sound absorbent panel, rear wheel housing
| Sound absorbent panel, rear wheel housing |
| To remove |
| 1. |
Remove the
rear seat back rest
.
|
|
| 2. |
Lift off the floor panel from the centre mounting of the rear back rest. Lift out the floor panel.
|
|
| 3. |
Remove the 3 two-stage rivets from the parcel shelf.
|
|
| 4. |
Remove the
Side bolsters.
|
|
| 5. |
Remove the clips which attach the luggage compartment inspection cover using special tool
84 71 179 removal tool, clips
and remove the inspection cover.
|
|
| 6. |
Remove the two-stage rivets and the two clips which attach the luggage compartment side trim. Use the
84 71 179 removal tool, clips
. Remove the side trim.
|
|
| 7. |
Using
84 71 179 removal tool, clips
remove the cable clips holding the cabling to the sound absorbent panel and push aside the cabling.
|
|
| 8. |
Remove the two plugs holding the sound absorbent panel.
|
|
| 9. |
Remove the sound absorbent panel.
|
|
| To fit |
| 1. |
Fit the sound absorbent panel with the two plugs.
|
|
| 2. |
Fit the cables to the sound absorbent panel with the cable clips.
|
|
| 3. |
Fit the luggage compartment side trim with the two-stage rivets and the two clips.
|
|
| 4. |
Fit the luggage compartment inspection cover with the clips.
|
|
| 5. |
Fit the
Side bolsters
.
|
|
| 6. |
Fit the 3 two-stage rivets on the parcel shelf.
|
|
| 7. |
Lift in the floor panel. Make sure that the floor panel is correctly located over the centre mounting of the rear back rest.
|
|
| 8. |
Fit the
rear seat back rest
.
|
|
