SAAB WIS ONLINE

PRE-RELEASE

Silencer, front, A20NFT/LHU

Silencer, front, A20NFT/LHU

To remove


1. Raise the car.

2. Remove the exhaust clamp (A).


3. 3. Cut the exhaust pipe (D) 100 mm from the rear silencer (C). Use 83 95 667 Pipe cutter/exhaust system .

4. Remove the front silencer (B).


To fit


1. Clean the joints and connecting pipe.

2. Fit the joint clamp.


3. Fit the front silencer (B) with new rubber mountings (E).

4. If necessary also replace the rubber mountings (E) for the rear silencer (C).

5. Adjust the joint clamp so that the pipe ends are in the middle of the clamp.

6. Adjust the front silencer (B) and rear silencer (C) so they hang evenly.

7. For cars with visible tailpipe, adjust this so that it hangs in the centre of the tailpipe cutout in the rear bumper.

8. Tighten the rear joint clamp's nuts.

Tightening torque 40 Nm (30 lbf ft)

9. Lower the car

10. Connect an exhaust hose and start the engine. Check the exhaust system for leaks.


PRE-RELEASE