PRE-RELEASE
Valve, limited slip differential clutch, replacement, A20NFT
| Valve, limited slip differential clutch, replacement, A20NFT |
|
|||||||
Warning
| Important | ||
|
It is very important to observe maximum cleanliness when working on the differential clutch. Dirt particles can seriously damage the function and service life of the differential clutch. |
||
| To remove |
| 1. |
Raise the car.
|
|
| 2. |
Remove
Complete exhaust system, A20NFT/LHU
.
|
|
| 3. |
Remove
propeller shaft
.
|
|
| 4. |
Remove the hooks (A) from the control module and take the protective cover (B) off the hydraulic pump.
|
|
| 5. |
Undo the cable clips (A).
|
|
| 6. |
Dismantle the electrical connection (A).
|
|
| 7. |
Support the differential clutch and limited slip differential with a pillar jack, secure with a strap (A).
|
|
| 8. |
Remove screws (B) from the differential clutch and limited slip differential.
|
|
| 9. |
Lower the differential clutch and limited slip differential enough to remove the valve, be careful not to damage the drive joints.
|
|
| 10. |
Dismantle the electrical connection (A).
|
|
| 11. |
Remove the valve with cover.
|
|
| 12. |
Remove the valve from the cover.
|
|
| To fit |
| 1. |
Fit the valve in the cover.
|
|
| 2. |
Fit the valve with cover (B).
Tightening torque 2.9 Nm (2.1 lbf ft) 
|
|
| 3. |
Fit the electrical connection (A).
|
|
| 4. |
Raise the differential clutch and limited slip differential.
|
|
| 5. |
Fit screws (B) to the differential clutch and limited slip differential.
Tightening torque: 90 Nm (66.4 lbf ft) + 90°+15°
|
|
| 6. |
Remove the strap (A).
|
|
| 7. |
Fit the electrical connection (A).
|
|
| 8. |
Fit the cable clips (A).
|
|
| 9. |
Fit the protective cover (A) to the hydraulic pump and attach the hooks (B) to the control module.
|
|
| 10. |
Fit the
propeller shaft
.
|
|
| 11. |
Fit
Complete exhaust system, A20NFT/LHU
.
|
|
| 12. |
Lower the car to the floor.
|
|
