SAAB WIS ONLINE

PRE-RELEASE

Transmission control module, TCM

Transmission control module, TCM

To remove

Before removing the control module to change it, perform Before removing a control module


1. Detach the engine's wiring harness from the coolant hose.

Important

Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves straight apart to avoid bending the pins. For further information regarding connectors, refer to Connectors, handling and inspection .


2. Pull out the lock pin, press down the lock and unplug the control module connector.


3. Put the gear selector in position P and undo the nut to the lever. Engage position N before removing the lever.


4. Remove the lever. Pull back the gear cable and lift it up.

5. Remove the bolts securing the control module.

6. Lift the control module off the shaft and connector. Lift straight up to avoid damaging the connector on the gearbox.


To fit


1. Set the inner, rotating section of the control module so that the arrow is pointing towards the marking on the housing.


2. Fit the control module. Press the control module carefully down onto the shaft and connector in the gearbox. It may be necessary to rotate the inner section of the control module slightly so that it fits the shaft. Fit the bolts.

Tightening torque 25 Nm (18 lbf ft)

3. Fit the control module connector and press in the lock pin.


Important

Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further information regarding connectors, refer to Connectors, handling and inspection .


4. Fit the lever and gear cable. Put the gear selector in position P.

Tightening torque 20 Nm (17 lbf ft)


5. Attach the engine's wiring harness to the coolant hose.

6. Upon control module replacement: Carry out Procedure after control module installation and service programming if necessary. Also carry out Adaptation, resetting .

7. Perform programming of the gear selector position sensor in neutral using the diagnostic tool.


PRE-RELEASE