PRE-RELEASE
Adjusting gear cables
| Adjusting gear cables |
| Adjustment |
| 1. |
Engage neutral gear.
|
|
| 2. |
Lift in the selector shaft slightly and insert
87 92 335 Lock pin
into the hole in the shaft.
|
|
| 3. |
Detach the gear lever cover and rubber mat and lift up the cover. Use
82 93 474 Removal tool
.
|
|
| 4. |
Carefully press a screwdriver blade onto the cable adjuster and pry slightly towards the gear lever. A click is heard which means that the adjustment catch has released. Repeat the procedure on the other cable adjuster.
|
||||||||||
| 5. |
Secure the gear lever in its adjustment position by lifting the adjusting sleeve while pressing in the two catches. Use a suitable pair of pliers. Lower the adjusting sleeve carefully and allow the catch to engage the recess in the gear lever housing (adjusting position, neutral to the left).
|
|
| 6. |
Move the gear lever to the left.
Hold it in this position and at the same time press the screwdriver against the crescent shaped section of the adjustment catch. When a click is heard the catch has engaged the correct position. Repeat the procedure on the other cable adjuster. 
|
||||||||||
| 7. |
Lift up the adjusting sleeve to its normal position and make sure the catches lock.
|
|
| 8. |
Remove the lock pin.
|
|
| 9. |
Check the shifting positions.
|
|
| 10. |
Fit the gear lever cover and rubber mat.
|
|
