PRE-RELEASE
Delivery line for power steering, A20NFT/LHU
| Delivery line for power steering, A20NFT/LHU |
| Important | ||
|
Scrupulous cleanliness must always be observed during all work with hydraulic components. |
||
| Important | ||
|
Always use wing covers when working in the engine bay. |
||
| To remove |
| 1. |
Lift off the battery cover and disconnect the negative battery cable.
|
|
| 2. |
Remove the right-hand wheel arch liner.
|
|
| 3. |
Lower the subframe about 100 mm (4 in). See
Subframe, A20NFT/LHU
.
|
|
| 4. |
Position a receptacle under the car. Remove the delivery line (A) from the steering gear and plug the connection.
|
|
| 5. |
Remove the delivery line from the power steering pump (B).
|
|
| 6. |
Remove the delivery line.
|
|
| To fit |
| 1. |
Attach the delivery line to the power steering pump (B).
Tightening torque 27 Nm (20 lbf ft)
|
|
| 2. |
Fit the delivery line (A) to the steering gear. Use new O-rings.
Tightening torque 32 Nm (24 lbf ft) |
|
| 3. |
Wipe clean any spilled oil from the subframe.
|
|
| 4. |
Install
Subframe, A20NFT/LHU
.
|
|
| 5. |
Install the right-hand wheel arch liner.
|
|
| 6. |
Connect the negative battery cable and fit the battery cover.
|
|
| 7. |
Fill with power steering fluid and bleed the power steering steering system, see
Hydraulic system EHPS, filling and bleeding, A20NFT/LHU
.
|
|
| 8. |
Carry out
Procedures after disconnecting the battery.
|
|
