PRE-RELEASE
Power steering delivery pipe, LHD
| Power steering delivery pipe, LHD |
| Important | ||
|
Scrupulous cleanliness must always be observed during all work with hydraulic components. |
||
| Important | ||
|
Always use wing covers when working in the engine bay. |
||
| To remove |
| 1. |
Lift off the battery cover and disconnect the negative cable from the battery.
|
|
| 2. |
Z18
|
|
| • |
Remove the hose and the mass air flow sensor.
|
| • |
Remove the clip from the bracket.
|
| • |
Remove the connector for the power steering unit.
|
| 3. |
Z19
|
|
| • |
Raise the car.
|
| • |
Remove the lower engine cover.
|
| • |
Remove the connector for the power steering unit.
|
| • |
Remove the clip from the bracket.
|
| • |
Lower the car to the floor.
|
| 4. |
Z19:
Detach the water hoses to the heater package at the plastic holder and bend them aside.
|
|
| 5. |
Unhook the coolant reservoir and move it to one side. Remove the brake fluid sensor connector.
|
|
| 6. |
Place a receptacle under the car.
|
|
| 7. |
Empty the power steering fluid reservoir using suitable oil draining equipment.
|
|
| 8. |
Remove the delivery pipe using
89 96 803 Power steering pump hydraulic pipe spanner, 18 mm
fitted to a 1/2" ratchet handle with reducer socket.
|
|
| 9. |
Remove the bolt holding the pipe to the steering gear.
|
|
| 10. |
Remove the power steering delivery pipe.
|
|
| To fit |
| 1. |
Put in place the delivery pipe.
|
|
| 2. |
Attach the power steering pipes to the steering gear.
Tightening torque 20 Nm (14.8 lbf ft) |
|||||||
| 3. |
Attach and tighten the delivery pipe to the hydraulic unit.
Tightening torque 27 Nm (20 lbf ft) |
|
| 4. |
Z19:
Fit the water hoses in the plastic holder.
|
|
| 5. |
Fit the coolant reservoir and attach the brake fluid sensor connector.
|
|
| 6. |
Z18
|
|
| • |
Plug in the connector to the power steering unit.
|
| • |
Fit the clip to the bracket.
|
| • |
Wipe away any spilled power steering fluid.
|
| • |
Fit the hose and the mass air flow sensor.
|
| 7. |
Z19
|
|
| • |
Raise the car.
|
| • |
Plug in the connector to the power steering unit.
|
| • |
Fit the clip to the bracket.
|
| • |
Wipe away any spilled power steering fluid.
|
| • |
Fit the lower engine cover.
|
| • |
Lower the car.
|
| 8. |
Connect the negative battery cable and fit the battery cover.
|
|
| 9. |
Fill with power steering fluid and bleed the system, see
Hydraulic system EHPS, filling and bleeding
.
|
||||||||||
| 10. |
Check for leaks in the delivery and return lines.
|
|
| 11. |
Carry out
Procedures after disconnecting the battery
.
|
|
