Power steering return pipe, LHD
|
|
Power steering return pipe, LHD
|
|
Important
|
|
Scrupulous cleanliness must always be observed during all work with hydraulic components.
|
|
|
|
Important
|
|
Always use wing covers when working in the engine bay.
|
|
|
|
1.
|
Lift off the battery cover and disconnect the negative cable from the battery.
|
|
2.
|
Z19
|
|
|
•
|
Remove the lower engine cover.
|
|
|
•
|
Lower the car to the floor.
|
|
|
•
|
Detach the water hoses to the heater package at the plastic holder and bend them aside.
|
|
3.
|
Unhook the coolant reservoir and move it to one side. Remove the brake fluid sensor connector.
|
|
4.
|
Place a receptacle under the car.
|
|
5.
|
Empty the power steering fluid reservoir using suitable oil draining equipment.
|
|
7.
|
Remove the bolt holding the pipe to the steering gear.
|
|
8.
|
Remove the return pipe and hose clip.
|
|
1.
|
Put in place the return pipe.
|
|
2.
|
Attach the power steering pipes to the steering gear.
|
Note
|
|
Take care not to damage the O-rings.
|
Tightening torque 20 Nm (14.8 lbf ft)
|
|
3.
|
Fit the return hose to the power steering fluid reservoir with a new hose clip.
|
|
4.
|
Fit a new O-ring and attach the delivery pipe to the hydraulic unit and tighten it.
Tightening torque 27 Nm (20 lbf ft)
|
|
5.
|
Z19:
Fit the water hoses in the plastic holder.
|
|
6.
|
Fit the coolant reservoir and attach the brake fluid sensor connector.
|
|
|
•
|
Wipe away any spilled power steering fluid.
|
|
|
•
|
Fit the lower engine cover.
|
|
|
•
|
Lower the car to the floor.
|
|
8.
|
Z18:
Wipe away any spilled power steering fluid.
|
|
9.
|
Connect the negative battery cable and fit the battery cover.
|
|
10.
|
Fill with power steering fluid and bleed the system, see
Hydraulic system EHPS, filling and bleeding
.
|
Important
|
|
The EHPS system must not be run dry. Do not reuse drained fluid. Fill the hydraulic system with special fluid.
|
|
|
|
|
11.
|
Check the delivery and return pipes for leaks.
|
