PRE-RELEASE
Subframe bush, B207
| Subframe bush, B207 |
| Note | ||
|
This method involves destructive disassembly. It is not possible to refit the old bush. |
| To remove |
| 1. |
Remove subframe, see
Subframe B207
or
Subframe, To remove and to fit, Z19
|
|
| 2. |
Cut away the rubber from the bush.
|
|
| 3. |
Saw or cut a groove on either side. Break off the flange from the bush to make room for the support.
|
|
| 4. |
Cut away the rubber edge protruding from the underside of the bush.
|
|
| 5. |
Remove the bush using a pull rod 907 and press sleeve KM 907-14 from
89 96 779 Set of press sleeves, front assembly
and a support from
89 96 902 Subframe bush set
|
|
| To fit |
| Note | ||
|
Make sure the bush is pressed in straight. |
| 1. |
Press in the bush using sleeves from the
89 96 902 Subframe bush set
.
|
|
| 2. |
Install subframe, see
Subframe B207
or
Subframe, To remove and to fit, Z19
|
|
