SAAB WIS ONLINE

PRE-RELEASE

Anti-roll bar link, replacement

Anti-roll bar link, replacement

To remove


1. Raise the car.

2. Remove the appropriate rear wheel.

3. Unplug the wheel sensor connector (A).


4. Remove the anti-roll bar screw (B) from the steering swivel member.

5. Remove the anti-roll bar link:

• Lubricate the damping rubber with Vaseline, non-acidic .

• Press the link away from the anti-roll bar using a suitable tool.


To fit


1. Fit a new link to the anti-roll bar:

• Lubricate the damping rubber with Vaseline, non-acidic .

• Press the link into the anti-roll bar using a suitable tool. Check that the link is correctly aligned on the anti-roll bar.

2. Fit the anti-roll bar link onto the steering swivel member using a new screw (B).

Tightening torque 53 Nm (39 lbf ft)


3. Plug in the wheel sensor connector (A).

4. Fit the Wheel .

5. Lower the car to the floor.


PRE-RELEASE