PRE-RELEASE
Spring, 4WD
| Spring, 4WD |
| To remove |
| 1. |
Raise the car.
|
|
| 2. |
Remove the wheel.
|
|
| 3. |
Remove and suspend the hydraulic body.
|
|
| 4. |
Remove the bush bolts (A) and move aside the anti-roll bar (B).
|
|
| 5. |
Compress the spring with
88 18 791 Spring compressor
and the small jaws. Lift out the spring.
Remove the spring from the tool. 
|
|
| To fit |
| 1. |
Compress the spring with
88 18 791 Spring compressor
and place the spring support in the spring.
|
|
| 2. |
Lift the spring into position. Remove the spring compressor.
|
|
| 3. |
Fit the hydraulic body.
Tightening torque 28 Nm (21 lbf ft) |
|
| 4. |
Fit the
Wheel
.
|
|
| 5. |
Use the same method to replace the spring on the other side.
|
|
| 6. |
Bend up the anti-roll bar (B) and fit the bush bolts (A).
Tightening torque 30 Nm (23 lbf ft). New illustration
|
|
| 7. |
Lower the car to the floor.
|
|
| 8. |
After spring replacement on cars with xenon headlights
: Carry out
Control module calibration
and light alignment (see
Headlight alignment
or
Headlight alignment (US/CA)
.
|
|
