PRE-RELEASE
Door handle, CV
| Door handle, CV |
| To remove |
| 1. |
Remove
Door trim, CV
.
|
|
| 2. |
Left door:
Remove
Side window, door, CV
.
Right door: Raise the window to the highest position. Fold down the water barrier. |
|
| 3. |
Cars with guard
: Remove the guard's screws.
|
|
| 4. |
Remove the lock cover from the rod.
|
|
| 5. |
Loosen the rod from the clip.
|
|
| 6. |
Remove the lock unit bolts. Allow the lock to hang freely.
|
|
| 7. |
Cars with guard
: Remove the guard by pulling the guard forward and downward and then lifting it out.
|
|
| 8. |
Remove the upper rear nut for the handle and lock cylinder.
|
|
| 9. |
Left door
: Turn the lock cylinder anti-clockwise and pull out the cylinder from the handle.
|
|
| 10. |
Left door
:Unhook the cylinder and remove the cylinder from the lock rod.
|
|
| 11. |
Remove the nuts from the opening handle.
|
|
| 12. |
Remove the reinforcement plate.
|
|
| 13. |
Lift out the handle by:
|
|
| 13.A. |
Pull out the lower edge of the handle so that the studs release.
|
| 13.B. |
Pull downwards to get out the handle counterweight.
|
| 13.C. |
Now lift upwards to get the handle's rod out through the hole.
|
| To fit |
| 1. |
Check the handle's gasket so that it is in one piece and located correctly.
|
|
| 2. |
Fit the handle by:
|
|
| 2.A. |
Fit the handle rod in the door.
|
| 2.B. |
Angle in the handle's counterweight.
|
| 2.C. |
Angle in the handle's lower edge and insert the studs in the holes.
|
| 3. |
Fit the reinforcement plate.
|
|
| 4. |
Fit the front and lower rear nuts on the opening handle.
|
|
| 5. |
Left door
: Hook the lock cylinder to the rod.
|
|
| 6. |
Left door
: Fit the lock cylinder by pushing the lock cylinder and turning it clockwise.
|
|
| 7. |
Fit the handle's upper rear nut.
|
|
| 8. |
Cars with guard
: Insert the guard. Make sure the rod from the handle is in front of the guard.
|
|
| 9. |
Lift up the lock and secure it with a bolt. Also, thread the bolts for the guard (certain cars only) and lock. Start by tightening the lock bolts followed by the guard bolts.
|
|
| 10. |
Push the rod into the clip.
|
|
| 11. |
Lift in the clip at the same time as you fit the lock cover to eliminate play.
|
|
| 12. |
Check the function of the handle, lock cylinder and lock.
|
|
| 13. |
Left door
: Fit
Side window, door, CV
.
|
|
| 14. |
Fit the plastic water barrier.
|
|
| 15. |
Fit the
Door trim
.
|
|
| 16. |
Cars with pinch protection
: Perform
Programming of the pinch protection
.
|
|
