PRE-RELEASE
Control module, door
| Control module, door |
Only applies to SE, GB and DE markets: Before replacing a control module the normal fault diagnosis in accordance with WIS must be carried out, and the Checklist for replacement of control module, DZM must have been worked through.
| To remove |
| 1. |
Perform
Preparations prior to removing a control module.
|
|
| 2. |
Remove the
Front door trim
.
|
|
| 3. |
Lay the side of the door on a clean and soft surface.
|
|
| 4. |
When changing the driver door module:
Remove the cell block from under the door module.
|
|
| 5. |
When changing the driver door module:
Remove door trim screw.
|
|
| 6. |
Remove the door module using a screwdriver. First undo the rear clip.
Then undo the clips on the outer and inner sides of the door module. Pull the module carefully back/down. |
|
| To fit |
| 1. |
Fit the door module pressing it obliquely upward so that the clip engages.
|
|
| 2. |
When changing the driver door module:
Fit the door trim screw.
|
|
| 3. |
When changing the driver door module:
Affix the cell block with double-sided tape. The use of 16-30 20 807 is recommended.
|
|
| 4. |
Make sure the door trim clips are in place and intact. Replace the clips if necessary.
|
|
| 5. |
Fit the door trim
.
|
|
| 6. |
Cars with pinch protection:
Perform
Programming of the pinch protection
.
|
|
| 7. |
If the control module has been changed
, perform
Measures after changing the control module
|
|
