PRE-RELEASE
Fourth bow
| Fourth bow |
| Removing |
| 1. |
Remove the
Headlining
until the headlining plastic holder can be removed from the fourth bow.
|
|
| 2. |
Detach the outer roof from the fourth bow.
|
|
| 3. |
Remove the seal by pulling it out of the middle part of the U-shaped rail. Unhook the upper part of the seal from the fastener. Let the seal hang.
|
|
| 4. |
Unhook the outer roof attaching profiles from the rear rails.
|
|
| 5. |
Remove the hydraulic line mounting from the right-hand side of the fourth bow.
|
|
| 6. |
Drill out the blind rivets for the fourth bow guide strap.
|
|
| 7. |
Remove the reinforcing bow bolts on one side.
|
|
| 8. |
Remove the retaining clips and the fourth bow.
|
|
| Fitting |
| 1. |
Place the fourth bow in mounting position. Fit the retaining clips.
|
|
| 2. |
Put the reinforcing bow and the bow's guide straps in mounting position. Fit the bolts.
|
|
| 3. |
Fit the blind rivets to the fourth bow guide strap.
|
|
| 4. |
Fit the mounting to the hydraulic lines on the right-hand side of the fourth bow.
|
|
| 5. |
Hook the outer roof attaching profiles to the rear rails.
|
|
| 6. |
Fit the rear rail seals. Hook the top part of the seal to the mounting and then press it into the rail
|
|
| 7. |
Remove the soft top support and raise the soft top fully.
|
|
| 8. |
Affix new double-sided adhesive tape to the fourth bow. Fold the fabric tabs of the outer roof around the fourth bow. Observe the centre markings on the parts.
|
|
| 9. |
Operate the soft top half way down and secure it with the soft top support to prevent it falling down when the hydraulic pressure drops.
|
|
| 10. |
Fit the
Headlining
.
|
|
