CIM / U2100 00
Read the instructions below then
start the fault diagnostic procedure.
CIM was Missing on P-Bus
On-board diagnosis
Type of diagnosis:
Enable criteria:
| Voltage is over 9V but under 16V |
Fault criteria:
System reaction to a fault:
Checking the wiring harness
| • | Faults in the control module female connector can be the cause of the DTC. Check the connector with respect to oxidation, depressed pins and pin clamping force. |
| • | Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force. |
Diagnostic help
Diagnosis regards:
Functions in the diagnostic tool related to the fault:
| Read / Reset Bus Configuration |
| (See also description of readings/activations in diagnostic tool) |
