SAAB WIS ONLINE

PRE-RELEASE

Fuel Pressure Relief

Fuel Pressure Relief


Warning

Fuel that exits the fuel tank at high pressure can cause serious injury to the skin and eyes. ALWAYS depressurize the fuel system before removing components that are under high fuel pressure.



1.
Note

If a scan tool is not available, WAIT at LEAST 2 hours after the engine has been run, before removing the high pressure fuel line.


Install a scan tool to the vehicle and command the fuel pump relay OFF, allowing the low pressure fuel pump to shut off.

2. Start the vehicle and allow the engine to idle until the engine stops. The engine will stop in approximately 20-30 seconds.

3. Turn the ignition OFF.

4. Using the scan tool, verify that there is little to no fuel pressure, if there still is fuel pressure repeat step 2.


PRE-RELEASE