Catalytic Converter Replacement - Right Side (LF1)
|
|
Catalytic Converter Replacement - Right Side (LF1)
|
|
Callout
|
Component Name
|
Preliminary Procedures
|
2.
|
Disconnect the heated oxygen sensors before and after the right catalytic converter.
|
|
|
1
|
Nut (Qty: 4)
Refer to
Fastener Caution
.
Warning
|
|
To prevent damage to the exhaust manifold flange or stud, make sure the flange is fully seated before tightening.
|
|
|
|
|
|
Procedure
|
1.
|
Remove the right exhaust manifold nuts (1).
|
|
2.
|
Remove the right exhaust manifold studs on the right cylinder head (if necessary).
|
|
3.
|
Replace the nuts (1) and gasket (2).
|
|
4.
|
Clean and inspect the studs on the engine cylinder head. Replace if necessary.
|
|
5.
|
Verify that the studs are fully seated. Stud collar should touch the surface of the engine cylinder head.
|
|
6.
|
Tighten nuts in a criss-cross pattern.
|
Tighten
|
•
|
First Pass 20 Nm (15 lb ft)
|
|
•
|
Final pass 46 Nm (34 lb ft).
|
|
|
2
|
Gasket
|
Note
|
|
Improperly installed and/or leaking exhaust manifold gaskets may affect vehicle emissions and/or On-Board Diagnostics (OBD) II system performance.
|
|
|
3
|
Catalytic Converter
|
