PRE-RELEASE
Generator Replacement (LAU)
| Generator Replacement (LAU) |
| Removal Procedure |
| 1. |
Disconnect the negative battery cable. Refer to
Battery negative cable disconnection and connection
.
|
|
| 2. |
Remove the drive belt. Refer to
Drive Belt Replacement
.
|
|
| 3. |
Reposition the positive battery cable boot at the generator terminal.
|
|
| 4. |
Disconnect the engine harness electrical connector (1) from the generator.
|
|
| 5. |
Remove the positive battery cable nut (3) at the generator.
|
|
| 6. |
Remove the positive battery cable terminal (4) from the generator.
|
|
| 7. |
Remove the idler pulley bolt (1) and idler pulley (2). Refer to
Drive Belt Idler Pulley Replacement
.
|
|
| 8. |
Remove the generator bolts (3).
|
|
| 9. |
Remove the generator (4). |
|||||||
| Installation Procedure |
| 1. |
Position the generator (4) to the engine.
|
|
| 2. |
Loosely install the generator bolts (3).
|
|
| 3. |
Install the idler pulley. Refer to
Drive Belt Idler Pulley Replacement
.
|
|
| 4. |
Refer to
Fastener Caution
.
Tighten the generator bolts (3) in the sequence shown to 58 Nm (43 lb ft) . |
|
| 5. |
Install the drive belt. Refer to
Drive Belt Replacement
.
|
|
| 6. |
Connect the engine harness electrical connecto (1) to the generator.
|
|
| 7. |
Install the positive battery cable terminal (4) to the generator.
|
|
| 8. |
Install the positive battery cable nut (3) at the generator and tighten to
15 Nm (11 lb ft)
.
|
|
| 9. |
Position the positive battery cable boot at the generator terminal.
|
|
| 10. |
Connect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
.
|
|
