PRE-RELEASE
Rear Object Sensor Housing Replacement
| Rear Object Sensor Housing Replacement |
| 1. |
Remove the rear fascia. Refer to
Rear Bumper Fascia Replacement
.
|
|
| 2. |
Disconnect the sensor harness.
|
|
| 3. |
Remove the sensor from the sensor housing.
The sensor housing must be painted if replaced. If reinstalled, painting will not be necessary. |
|
| 4. |
Sand/grind sonic weld plastic residue from the fascia. 
|
|||||||
| 5. |
Apply structural adhesive epoxy, Lord Fusor™ 127EZ or equivalent, to fascia at mating surface.
|
|
| 6. |
Using the alignment tabs, install the sensor housing to the fascia.
|
|
| 7. |
Allow adhesive to cure according to manufacturer's directions.
|
|
| 8. |
Install the sensor to the sensor housing.
|
|
| 9. |
Connect the electrical harness.
|
|
| 10. |
Install the rear fascia. Refer to
Rear Bumper Fascia Replacement
.
|
|
