SAAB WIS ONLINE

PRE-RELEASE

Front Compartment Fuse Block Replacement

Front Compartment Fuse Block Replacement



Callout Component Name

Preliminary Procedures

1. Disconnect the battery. Refer to Battery Negative Cable Disconnection and Connection .

2. Remove the windshield washer container filler neck. Refer to Windshield Washer Solvent Container Filler Tube Replacement .


1 Accessory Wiring Junction Block Cover

Procedure

Remove the accessory wiring junction block cover by pushing in on the 3 retainer tabs located on the ends of the cover and lift. To reinstall, fit together the retainer tabs located on the ends of the cover and push down on the cover until the tabs on the ends of the cover lock into place.
2 Accessory Wiring Junction Block Refer to Fastener Caution .

Procedure

Disconnect the battery positive cable from the junction block by removing the nut.

Tighten

7 N m (62 lb in)
3 Accessory Wiring Junction Block Harness Connector Bolt (Qty: 3)

Procedure

1. Release the junction block retainers and remove the junction block from the base.

2. Remove the accessory wiring harness from the accessory wiring junction block retainer.


Tighten

10 N m (89 lb in)
4 Accessory Wiring Junction Block Retainer Base Nut

Tighten

20 Nm (15 lb ft)
5 Accessory Wiring Junction Block Retainer Base

Procedure

Position the junction block retainer base alignment tab to the bracket first, then install the nut.


PRE-RELEASE