Rear Differential Clutch Control Module Replacement
|
|
Rear Differential Clutch Control Module Replacement
|
|
Callout
|
Component Name
|
Preliminary Procedures
Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
|
|
1
|
Protective Cover
|
|
2
|
Differential Clutch Control Module Bolts (Qty: 2)
Warning
|
|
The hydraulic pressure in the differential clutch is very high. To prevent personal injury, wait for at least 10 minutes before removing any parts from the differential clutch.
|
|
|
|
|
|
Refer to
Fastener Caution
.
Procedure
DO NOT remove the mounting bolts, leave them attached to the Differential Clutch Control Module.
Tighten
6 Nm (53 lb in)
|
|
3
|
Rear Differential Clutch Control Module and Seal
Procedure
|
1.
|
Disconnect the electrical connector.
|
Note
|
|
Some oil leakage can take place with the differential clutch control module and valve dismantled.
|
|
|
2.
|
If the Differential Clutch control Module and the valve separate, perform the following:
|
|
|
2.1.
|
Pull the valve straight out of the bore.
|
|
|
2.2.
|
Assembly the Differential Clutch control Module and the valve prior to the installation of the seal.
|
|
|
2.3.
|
Install a NEW seal. DO NOT re-use the old seal.
|
|
|
2.4.
|
Clean the area with a lint free cloth prior to installing the Differential Clutch Control Module and the valve.
|
|
