SAAB WIS ONLINE

PRE-RELEASE

Input Speed Sensor Replacement

Input Speed Sensor Replacement



Callout Component Name

Preliminary Procedures

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle

2. Drain the transmission, refill when repair is completed. Refer to Transmission Fluid Replacement

3. Remove the radiator air lower baffle and deflector assembly. Refer to Radiator Air Lower Deflector Replacement

4. Remove the left transmission mount and bracket. Refer to Transmission Mount Replacement - Left Side .

5. Remove the control valve body cover. Refer to Control Valve Body Cover Replacement .

6. Perform the service programming system procedure. Refer to Service Programming System (SPS) .


1 Input Speed Sensor (ISS) Wire Harness

Procedure

Attach the DT-47734 Speed Sensor Harness Tether to the ISS electrical connector locking tab before removal of old ISS to assist in installation of the new ISS.

Special Tools

DT-47734 Speed Sensor Harness Tether.
2 Input Speed Sensor Bolt M6 x 25 Refer to Fastener Caution .

Procedure

Apply threadlocker to the input speed sensor bolt. Refer to Adhesives, Fluids, Lubricants, and Sealers for the recommended threadlock material.

Tighten

9 N m (80 lb in)
3 Input Speed Sensor
Note

After an internal transmission repair or internal part replacement the service programming system procedure should be performed.


4 Input Speed Sensor Seal


PRE-RELEASE