PRE-RELEASE

Input Speed Sensor Seal Replacement

Callout

Component Name

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

Drain the transmission, refill when repair is completed. Refer to Transmission Fluid Replacement .

Remove the left wheel house. Refer to Front Wheelhouse Liner Replacement .

Input Speed Sensor Bolt M6 x 25 Refer to Fastener Caution .

Note
Apply threadlocker to the input speed sensor bolt. Refer to Adhesives, Fluids, Lubricants, and Sealers for the recommended threadlock material.

9 N m (80 lb in)

Input Speed Sensor (ISS)

Note
Pull the ISS out of the case cover just far enough to gain access to the ISS seal.

Input Speed Sensor Seal

Note
•	Remove the ISS seal by pulling it over the end of the ISS base.
•	Install the new ISS seal by gently stretching it over the ISS base. Overstretching the seal will cause it to not seal properly. The seal is coated with a dry lubricant. If the coating is missing, lubricate the seal with automatic transmission fluid prior to installation.