Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl Actuator Installation
|
|
Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl Actuator Installation
|
|
Callout
|
Component Name
|
|
1
|
Park Pawl Actuator Guide
|
|
2
|
Park Pawl Actuator Guide Pin
|
|
3
|
Park Pawl
|
|
4
|
Park Pawl Shaft
|
|
5
|
Park Pawl Spring
|
|
6
|
Park Pawl Actuator Bracket
|
|
7
|
Park Pawl Actuator Bracket Bolt M6 x 25 (Qty: 2)
Refer to
Fastener Caution
.
Tighten
12 Nm (106 lb in).
|
|
8
|
Park Pawl Actuator Assembly
|
Note
|
|
Install the park pawl actuator assembly onto the detent lever assembly.
|
|
|
9
|
Manual Shaft Detent (w/Shift Position Switch) Lever Assembly
|
Note
|
|
•
|
Rotate the assembly clockwise so the actuator rod will fit through the case opening.
|
|
•
|
Lubricate shaft with ATF to prevent damage to the manual shift shaft seal.
|
|
|
10
|
Manual Shift Shaft Pin
Warning
|
|
Use J 41229 to install the manual shaft pin at the correct height in order to properly secure the manual shaft. If you install the pin too deep, the case bore may crack.
|
|
|
|
|
|
Procedure
|
1.
|
Use a NEW pin to ensure proper engagement to the case.
|
|
2.
|
Inspect pin installed height is within 6.5-7.5 mm (0.25-0.30 in).
|
Special Tools
DT 41229
Manual Shaft Pin Installer
For equivalent regional tools, refer to
Special Tools
.
|
