PRE-RELEASE
Transmission Rear Mount Replacement (FWD)
| Transmission Rear Mount Replacement (FWD) |
| Removal Procedure |
| 1. |
Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
|
|
| 2. |
Remove the left tire and wheel. Refer to
Tire and Wheel Removal and Installation
.
|
|
| 3. |
Using a suitable jack stand, support the rear of the powertrain.
|
|
| 4. |
Remove the transmission mount to bracket through bolt (1).
|
|
| 5. |
Remove the transaxle brace bolt (1), then loosen bolt (2) until it no longer engages the transaxle.
|
|
| 6. |
Remove the transaxle brace (3) with bolt (2) still retained in the brace.
|
|
| 7. |
Remove the transmission mount to transmission bolts (2).
|
|
| 8. |
Remove the rear mount to frame fasteners (1, 2), then remove the mount from the vehicle.
|
|
| Installation Procedure |
| 1. |
Refer to
Fastener Caution
.
Install the transmission mount bracket to transmission bolts (2) and tighten to 100 Nm (74 lb ft) .
|
|
| 2. |
Install the transaxle brace (3) with bolt (2) seated in the brace.
|
|
| 3. |
Install the transaxle brace bolt (1) and tighten to
58 Nm (42 lb ft)
.
|
|
| 4. |
Tighten the brace bolt (2) to
100 Nm (74 lb ft)
.
|
|
| 5. |
Install the transmission mount bracket to transmission bolt (1) and tighten to
100 Nm (74 lb ft)
.
|
|
| 6. |
Replace the bolts with NEW bolts (1) and tighten to
100 Nm (74 lb ft) plus 120 degrees
.
|
|
| 7. |
Remove the jack stand.
|
|
| 8. |
Install the left tire and wheel. Refer to
Tire and Wheel Removal and Installation
.
|
|
| 9. |
Lower the vehicle.
|
|
