SAAB WIS ONLINE

PRE-RELEASE

Line Pressure Check

Line Pressure Check



Special Tools

DT 21867-A Pressure Gauge

For equivalent regional tools, refer to Special Tools .


1.
Warning

Keep the brakes applied at all times in order to prevent unexpected vehicle motion. Personal injury may result if the vehicle moves unexpectedly.


Install a scan tool.

2. Start the engine.

3. Inspect the transmission for the proper fluid level. Refer to Transmission Fluid Level and Condition Check .

4. Use the scan tool to inspect for any active or stored diagnostic trouble codes.

5. Inspect the manual linkage at the transmission for proper function.

6. Turn OFF the engine.

7. Remove the line pressure test hole plug.

8. Install the DT 21867-A pressure gauge.

9. Access the Scan Tool Transmission Output Controls for the Line PC Solenoid.

10. Start the engine.

11.
Note

In order to achieve accurate line pressure readings, the following procedure must be performed at least 3 times in order to gather uniform pressure readings.

The scan tool is only able to control the line PC solenoid in PARK and NEUTRAL with engine speeds below 1500 RPM. This protects the clutches from extreme high or low line pressures.


Use the scan tool to increase and decrease the Line PC Solenoid in increments of approximately 200 KPa (29 psi). The scan tool commands the increment values automatically.

12. Allow the pressure to stabilize between increments.

13. Compare the pressure readings on the DT 21867-A pressure gauge to the actual pressure values in the solenoid valve pressure chart. Refer to Solenoid Valve Pressure .

14. If the pressure readings vary greatly, refer to Fluid Pressure High or Low .

15. Turn OFF the engine.

16. Remove the DT 21867-A pressure gauge.

17. Refer to Fastener Caution .

Install the line pressure test hole plug and tighten to 12 Nm (106 lb in) .


PRE-RELEASE