Steering Linkage Outer Tie Rod Inspection
|
|
Steering Linkage Outer Tie Rod Inspection
|
Special Tools
GE 8001
Dial Indicator Set
For equivalent regional tools, refer to
Special Tools
.
|
1.
|
|
Note
|
|
This inspection procedure does not supersede local government required inspections that have more stringent requirements.
|
Inspect the outer tie rod seal. If the outer tie rod seal is torn, replace the outer tie rod. Refer to
Steering Linkage Outer Tie Rod Replacement
.
|
|
2.
|
Raise the side of the vehicle being inspected with a floor jack while maintaining contact between the opposite wheel and the shop floor. Support the lower control arm with a floor jack stand as far outboard as possible and remove the floor jack. Refer to
Lifting and Jacking the Vehicle
.
|
|
3.
|
Install the
GE-8001
dial indicator between the outer tie rod and the steering knuckle as shown in the graphic. Note that the tire and wheel assembly is shown removed only for clarification of the
GE-8001
dial indicator.
|
|
4.
|
Grasping the tire at the 3 o'clock (2) and 9 o'clock (1) positions, gently push in on one side of the tire in order to remove any lash.
|
|
5.
|
Zero the
GE-8001
dial indicator.
|
|
6.
|
On the same side of the tire previously pushed in, gently pull out and measure the lash.
|
|
7.
|
Record the measurement shown on the
GE-8001
dial indicator.
|
|
9.
|
Repeat the procedure for the other side.
|
