PRE-RELEASE
DTC C0569
| DTC C0569 |
| Diagnostic Instructions |
| • |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
|
| • |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
|
| • |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
|
| DTC Descriptor |
DTC C0569 00
System Configuration Malfunction
| Circuit/System Description |
If the tire type and pressure selection information is not entered with the scan tool during the body control modue (BCM) setup, the tire pressure monitor indicator icon on the instrument panel cluster (IPC) will flash for 1 minute and then remain illuminated after the ignition switch is cycled ON and the IPC bulb check is complete. If equipped, the driver information center (DIC) will also display a service tire monitor type message. Under these circumstances, DTC C0569 will be set and the tire type and pressure information will need to be entered for the system to function correctly.
| Conditions for Running the DTC |
The ignition is ON.
| Conditions for Setting the DTC |
The BCM has not undergone the tire type and pressure selection setup procedure.
| Action Taken When the DTC Sets |
| • |
The tire pressure monitor indicator icon on the instrument panel cluster (IPC) will flash for 1 minute and then remain illuminated after the ignition switch is cycled ON and the IPC bulb check is complete.
|
|
| • |
If equipped, the driver information center (DIC) displays a service tire monitor type warning message.
|
|
| Conditions for Clearing the DTC |
A current DTC will clear when the BCM has undergone the tire type and pressure selection setup procedure and 1 ignition cycle has occurred.
| Diagnostic Aids |
A newly replaced BCM will set DTC C0569 on its initial ignition ON cycle if the module setup information has not been entered. The Tire Type and Tire Pressure Selection setup must be performed with the scan tool.
| Reference Information |
Description and Operation
Tire Pressure Monitor Description and Operation
Scan Tool Reference
Control Module References for scan tool information
Special Tools
EL-46079/J-46079 Tire Pressure Monitor Diagnostic Tool
| Circuit/System Verification |
Verify that the DTC C0569 is not set.
| Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for BCM replacement, programming and setup.
