SAAB WIS ONLINE

PRE-RELEASE

Rocker Panel Rear Molding Replacement

Rocker Panel Rear Molding Replacement



Callout Component Name

Preliminary Procedures

1. Remove the rear tire and wheel assembly from the side the rocker panel rear molding is being serviced. Refer to Tire and Wheel Removal and Installation .

2. Remove the two rear wheel panel liner screws.

3. Release the three retainers from the rear rocker panel using a trim-type release tool. Begin at the bottom working upward.


1 Rear Wheel Panel Liner Screw (Qty: 2) Refer to Fastener Caution .
2 Rocker Panel Rear Molding Retainer (Qty: 3)
3 Rocker Panel Rear Molding

Procedure

Pull the rear edge of the molding outward , then pull rearward to release the rocker panel rear molding from the rear edge of the rocker panel front molding.


PRE-RELEASE