PRE-RELEASE
Motor and sensor, backrest adjustment
| Motor and sensor, backrest adjustment |
| 1. |
Remove the front seat from the car, see
.
|
|
| 2. |
Undo the straps (A) holding the bottom of the backrest upholstery.
Undo the cables and their cable ties. Thread the cables through the hole. |
|
| 3. |
Detach the upholstery strips (B) at the bottom.
|
|
| 4. |
Pull out the sheet (C) from the backrest upholstery.
|
|
| 5. |
Undo the rear of the backrest upholstery (A) by loosening the upholstery strip along the sides and folding the upholstery to the side.
|
|
| 6. |
Detach the upholstery strip (B) along one side on the rear of the backrest frame.
|
|
| 7. |
Remove the knob for the lumbar support adjustment (C).
|
|
| 8. |
Undo the upholstery hooks at the bottom edge of the backrest.
|
|
| 9. |
Fold up the upholstery and the cushion to the side of the backrest.
|
|
| 10. |
Unscrew the backrest adjustment motor, 2 screws (A).
|
|
| 11. |
Lift the motor (B) from the pinion.
|
|
| 12. |
Unplug the connector (C) for the backrest adjustment motor.
|
|
| To fit |
| 1. |
Refit the motor (B) to the pinion.
|
|
| 2. |
Fit the backrest adjustment motor, 2 screws (A).
|
|
| 3. |
Plug in the connector (C) for the backrest adjustment motor.
|
|
| 4. |
Fold back the upholstery and the cushion on the side of the backrest.
|
|
| 5. |
Refit the upholstery hooks at the bottom edge of the backrest.
|
|
| 6. |
|
|
| 7. |
Refit the upholstery strip (B) along the side on the rear of the backrest frame.
|
|
| 8. |
Refit the rear of the backrest upholstery (A) by fitting the upholstery strip along the sides and folding in the upholstery.
|
|
| 9. |
Refit the sheet (C) from the backrest upholstery.
|
|
| 10. |
Fit the upholstery strips (B) at the bottom.
|
|
| 11. |
Thread the cables through the holes. Refit the cables and cable ties.
|
|
| 12. |
Fit the straps (A) holding the bottom of the backrest upholstery.
|
|
| 13. |
Fit the front seat in the car, see
.
|
|
