PRE-RELEASE
Light cluster in tailgate 5D
| Light cluster in tailgate 5D |
| To remove |
| 1. |
Open the tailgate.
|
|
| 2. |
Remove the frame around the inner locking handle.
|
|
| 3. |
Remove the inner trim from the tailgate by removing the screws securing the door pull and the plastic clips in the trim.
|
|
| 4. |
Pull down the top of the trim so that it comes away from the clips and then pull it backwards to release the clip at the door pull.
|
|
| 5. |
Unscrew the nuts securing the light cluster (5x on right side and 4x on left side).
|
|
| 6. |
Right side:
Pull out the lock and allow it to hang from the locking rod. Check the seal around the lock cylinder |
|
| 7. |
Remove the light cluster.
|
|
| To fit |
| 1. |
Put the light cluster in position.
|
|
| 2. |
Right side:
Fit the lock without damaging the seal. |
|
| 3. |
Screw in the lamp.
|
|
| 4. |
Fit the inner trim by inserting the clip at the door pull and fastening the trim in the clips. Screw in the two screws in the door pull.
|
|
| 5. |
Fit the frame around the inner handle.
|
|
