PRE-RELEASE
Headlamp housing, upper mounting
| Headlamp housing, upper mounting |
| 1. |
If required, remove the glass.
|
|
| 2. |
Protect the reflector from dust and dirt.
|
|
| 3. |
Identify the type of plastic. See
or
|
|
| 4. |
Select the correct welding filler and set the temperature of the welding gun so that it agrees with the type of plastic. See
|
|
| 5. |
Secure the damaged area and tack using the tack welding tip on the welding gun.
|
|
| 6. |
Heat and right the lobe. Tack it with the welding gun.
|
|
| 7. |
Check the stamp on the headlamp housing and refer to the welding rod table to ensure you choose the correct welding filler. See
.
Weld the lobe in place |
|
| 8. |
Then weld the other joints around the upper mounting.
|
|
| 9. |
Allow the weld to cool.
|
|
| 10. |
Grind the welds if required.
|
|
| 11. |
If necessary remove any burrs from the joint using a welding gun and, if needed, a small screwdriver.
Remove any groves left after grinding by rapidly heating the repaired area with the welding gun set to a temperature approx. 25°C above the stipulated welding temperature. |
|
