PRE-RELEASE
Radiator, drain cock and guide pin
| Radiator, drain cock and guide pin |
| 1. |
Identify the type of plastic. See
or
|
|
| 2. |
Select the correct welding filler and set the temperature of the welding gun so that it agrees with the type of plastic. See
|
|
| 3. |
Tack the parts in place.
|
|
| 4. |
Weld the parts in place with welding filler.
|
|
| 5. |
Allow the weld to cool.
|
|
| 6. |
Grind the weld if required.
|
|
| Note | ||
|
The plastic stamp on a radiator can look as follows: |
||
|
PA - T 20; where the figure 20 states the percentage of filling material. Only radiators with max. 30% filling material can be welded. A radiator with the marking PA - T 40, for example, cannot be welded. |
