PRE-RELEASE
Rear bumper, 4D with towbar
| Rear bumper, 4D with towbar |
| 1. |
Undo the screws in the wheel housing, 2 on each side.
|
|
| 2. |
Open the boot lid.
|
|
| 3. |
Remove the luggage compartment sill.
|
|
| 4. |
Fold away the luggage compartment carpet and remove the seals. The old seals must be discarded and replaced by new ones:
|
|
| 5. |
Remove the nuts holding the bumper.
|
|
| 6. |
Remove the protective mouldings using
82 93 474 Removal tool
.
|
|
| 7. |
Remove the bolts from the inside and hold the nuts through the 2 holes behind the protective moulding.
Come cars have press nuts and in such cases it is sufficient to just remove the bolts. |
|
| 8. |
Detach the towbar connectors and the bolts holding the towbar to the body.
|
|
| 9. |
Together with an assistant, pull out the bumper from the clips and lift the bumper out backwards.
|
|
| 10. |
For cars equipped with Saab Parking Assistance (SPA):
Remove the connector.
|
||||||||||
| To fit |
| 1. |
For cars equipped with Saab Parking Assistance (SPA):
Attach the connector.
|
|
| 2. |
Place the towbar connector in the bumper cavity.
|
|
| 3. |
Place the bumper in position and press it over the edge of the wheel housing. Make sure that the clips sit correctly.
|
|
| 4. |
Fit the bumper's nuts and bolts.
|
|
| 5. |
Fit the screws in the edge of the wheel housing.
|
|
| 6. |
Fit the bolts and nut plates that secure the towbar to the body.
Attach the towbar connector. 
|
|
| 7. |
Fit new seals and fold down the luggage compartment carpet.
|
|
| 8. |
Fit the scuff plate.
|
|
| 9. |
Fit the luggage compartment carpet.
|
|
| 10. |
Fit the protective mouldings.
|
|
| 11. |
Close the boot lid and check the bumper fit.
|
|
