PRE-RELEASE
Rear bumper, 5D
| Rear bumper, 5D |
| 1. |
Remove the screws in the wheel housing, 2 on each side.
|
|
| 2. |
Open the tailgate
|
|
| 3. |
Remove the storage compartments and their covers on both sides.
|
|
| 4. |
Remove the insulation pads. The old ones must be discarded and replaced by new ones.
|
|
| 5. |
Remove the nuts holding the bumper. The lower bolts only have nuts if the car is equipped with a towbar.
|
|
| 6. |
Together with an assistant, pull out the bumper clips from the edges of the wheel housings and the rear wings. Lift the bumper out backwards.
|
|||||||||||||||||||
| To fit |
| Note | ||
|
For cars equipped with Saab Parking Assistance (SPA): |
||
| • |
Attach the connectors.
|
|
| 1. |
Place the bumper in position and press it over the edge of the wheel housing and the rear wing. Make sure that the clips sit correctly.
|
|
| 2. |
Put the nuts in place that hold the bumper.
|
|
| 3. |
Position the bumper correctly and tighten the screws in the edge of the wheel housing.
|
|
| 4. |
Tighten the nuts holding the bumper.
|
|
| 5. |
Fit the new insulation pads.
|
|
| 6. |
Fit the storage compartments and their covers on both sides.
|
|
| 7. |
Close the tailgate and check the fit of the bumper against the tailgate.
|
|
