PRE-RELEASE
Engine oil and oil filter
| Engine oil and oil filter |
| Check for oil leakage |
Make sure that no oil leaks on the top or under side of the engine/gearbox or the steering hydraulic system.
If oil leakage occurs in the auxiliaries, check and replace the drive belt if necessary.
| Engine oil |
Change the oil. Fill top the MAX marking. The distance between the markings is equal to a volume of 1 litre (1,05 qt.)
Check the level when the engine is warm 2-5 minutes after the engine has been shut off.
Oil volume
B205E, B235E: 4,0 litres (4,3 qt.) including filterB308E: 4,5 litres (4,8 qt.) including filter
Oil type
See Lubrication, lubricants .Drain plug, tightening torque:
B205E, B235E, B308E: 25 Nm (19 lbf ft)
Check the oil level after engine oil and oil filter change.
| Oil filter |
| 1. |
Loosen the oil filter with the strap wrench and unscrew the filter. Wipe the engine sealing surfaces clean.
|
|
| 2. |
Apply engine oil to the rubber oil filter gasket and fit the gasket. Tighten the filter by hand.
|
|
| 3. |
Check for leaks from the filter after starting the engine.
|
|
