SAAB WIS ONLINE

PRE-RELEASE

Checklist, general symptoms

Read the instructions below then start the fault diagnostic procedure.

Symptom: Use Tech2 to check the following readings and adaptation values.

Checklist, general symptoms


Checking

Use Tech2 to check the following readings and adaptation values.

Conditions

- The coolant temperature must be normal (>80°C) and the engine idling.

- The A/C system must be off (turn A/C to OFF or press "Econ").

- Fault codes must not be deleted before the values have been read.

Diagnostic procedure

Is there a DTC in the engine management system? If so, which:..................................

In Tech2 select: Engine - ECD V6 TID - Read Values / Activations. The following values are available:

Text

When ignition ON

When engine running

Expected values when idling

Air Mass Sensor

V

V

1.5 - 2

Coolant Temperature

°C

°C

80 - 100

Intake Air Temperature

°C

°C

10 - 60

Fuel Temperature

°C

°C

20 - 90

Atmospheric Pressure

kPa

kPa

90 - 115

Absolute pressure

kPa

kPa

90 - 115

Engine RPM

rpm

700 - 800

Airmass / Combustion

mg/c

500 - 700

Requested EGR*

%

0 - 95

EGR Ratio*

%

0 - 95

Target EGR Valve Position

mm

0 - 5

EGR Valve Position**

mm

0 - 5

Fuelmass / Combustion

mm³/c

3 - 8

Actual Injection Quantity

mm³/c

60

Requested VNT Position

mm

0 - 10

Actual VNT Position**

mm

0 - 10

Pedal Position Sensor 1

V

0.50 - 1.50

Pedal Position Sensor 2

V

0.25 - 0.75

Battery Voltage

V

13 - 15

Target Fuel Pressure

MPa

20 - 50

Fuel Pressure**

MPa

20 - 50



*) EGR regulation ceases about 60 - 180 seconds after idling starts. Read values while EGR regulation is active.

**) The value must be the same as the requested value.

Fuel quantity correction, cylinder 1 - 6. Fill in.

± 5 mm³/c

Cylinder 1

Cylinder 2

Cylinder 3

Cylinder 4

Cylinder 5

Cylinder 6

Correction injector 1 - 6. Fill in.

0 - 5 V

Cylinder 1

Cylinder 2

Cylinder 3

Cylinder 4

Cylinder 5

Cylinder 6



The following obligatory information can be found under “System information”:

VIN (E.g. YS3EF45D933019388)

Saab part number (e.g. 5342985)

Hardware number (e.g. 8973545870)

ECM software number (e.g. 16DS8C)

Software version (e.g. VS3MIKM6)



PRE-RELEASE