Speed, bus from TC/ABS/ESP
|
|
Speed, bus from TC/ABS/ESP
|
The TC/ABS/ESP control module sends bus message "Wheel speed, front right, XXX km/h” via the P-bus to the Trionic control module connection 19 and 66. This speed signal is used to:
|
•
|
prevent adaptation of idle speed control when the car is moving.
|
|
•
|
on manual gearboxes, determine which gear is currently being used. This makes it possible to limit torque in gears R and 1 and activate fuel shut-off in gears 2, 3, 4 and 5. Control of the SHIFT UP lamp also depends on the current gear.
|
|
•
|
activate speed limitation by limiting the maximum mass air flow/combustion at 240 km/h.
|
|
•
|
If the speed signal is missing, diagnostic trouble code P0502 will be generated.
|
|
•
|
If the speed value is implausible, diagnostic trouble code P0501 will be generated.
|
System reaction to a fault
|
•
|
Speed (bus from MIU) used as substitute value.
|
|
•
|
Cruise control blocked.
|
